|
TRAILER
MOUNTED CAMERA SYSTEM™
|
specifications |
Trailer Mounted
Camera Specifications
We use a closed circuit TV camera that is uniquely
assembled onto a trailer for use in work zones. It features a wireless
2.4 GHz video transmitter & receiver system with up to a 10+ mile
line of site range. This unit has been tested and is in compliance with
part 90 of the rules of the FCC.
Transmitter Specification:
RF output: 11.75 mW(without
6db antenna)
Input: NTSC or Pal 1Vpp
Channel Frequency: 2450-2483 MHz
Voltage: 10-13 Vdc@300 ma
Operation Temp: -30 C to +50 C
Receiver Specification:
RF Input Range: 2450-2483 MHz
Output: NTSC or PAL 1Vpp
Voltage: 10-13 Vdc@300ma
Operation Temp: -30 C to +50 C
Channel Frequency: 2450-2483 Mhz
The camera used ia an industrial grade, high sensitivity,
high resolution, dual mode color, black and white video camera with digital
signal processing. It is installed into a housing that integrates pan,
tilt, and zoom.
Camera Specification
Scanning System: NTSC standard
with 525 lines, 30 frames/Sec: 2:1 Interface
Synchronizing System: internal / line lock synchronization
Interlace: PLL 2:1 interlace
Resolution: color / black & white: horizontal 525TV lines
Controls: auto iris lens, electronic iris, color adjust, backlight compensation,
backlight mode, line lock phase, white balance
Operating Temperature Range: -10 C to +50 C within 90% humidity
Tilt Range: +40 to -90 degrees from horizontal
Camera Housing Specification
Built In Heater
Powder coated aluminum construction
Operating temperature range: -40C to +60 C
Meets NEMA 4X & IP66 standards
360 degree continuous pan rotation
Operation in 90 mph wind conditions (can withstand 130mph)
The on-board lifting device (mast) can safely
and rapidly raise the camera, housing and pan/tilt/zoom base, and shall
be capable of extending to a maximum height of 29 feet.
Mast Specification
It is free standing requiring no guide wires.
It is made from heat treated aluminum tubes and collars with low friction
synthetic bearings. The mast is raised pneumatically and will remain in
a fully extended position during use. It is capable of being manually
rotated and locked on its vertical axis for the purpose of aiming the
antenna. All mast controls shall be protecting from tampering.
All local control functions for the system
will be enabled from a single control cabinet located at the front of
the trailer.
Control Features
System: Power on/off
Mast: Up/Down
PTZ Controller: Power on/off
Presets: 1/2/3/4
Pan:auto/manual
Joystick: up/down/right/left
Zoom: in/out, Focus - near/far
Iris:open/close
Local Monitor: Brightness/Contrast/Vertical Hold
Power Control Unit:Battery Charging System - 0 to 50 amp analog meter
Solar Charging System: 0 to 50 amp analog meter
115V AC external power switch
 OVERVIEW
OPERATION
SPECIFICATIONS
|
